Installing Work Stop; Vertical Assembly - Grizzly G0622 Owner's Manual

Installing Work Stop

The work stop is designed to provide the operator
a quick reference for making multiple cuts at the
same length.
To install the work stop onto the bandsaw:
1.
KEEP BANDSAW UNPLUGGED!
2.
Install the work stop shaft into the side of the
bandsaw then lock it in place by tightening
the setscrew (see Figure 14).
Figure 14. Installing work stop shaft.
3.
Slide the work stop onto the end of the shaft
and lock it into position with the locking lever
shown in Figure 15.
Figure 15. Work stop locking lever.
G0622 4" X 6" Metal Cutting Bandsaw
-17-