FIRE HAZARD! DO NOT
cut
using oil-water solutions
as a cutting fluid! Always
use a cutting fluid intend-
ed for magnesium. The
water in the solution will
cause a magnesium-chip
fire.
4.
Adjust the valve on the coolant hose to
control the flow of coolant (see Figure 29).
Make sure that the pressure is not so high
that coolant spills on the floor and creates a
slipping hazard.
Figure 29. Coolant control valve.
5.
Turn the pump toggle switch ON before mak-
ing your cut.
G0561 7" x 12" Metal-Cutting Bandsaw
magnesium
when
-25-