Wheels & Leveling Feet; Chip Screen - Grizzly G0561 Owner's Manual

Wheels & Leveling
Feet
The wheels may be installed to make it easier to
move the G0561 bandsaw.
Components and Hardware Needed:
Wheels ............................................................... 2
Axle ................................................................... 1
Cotter Pins 3 x 30mm ........................................ 2
Leveling Feet with Hex Nuts ............................. 2
Flat Washers 10mm .......................................... 2
To install the wheels and leveling feet:
1.
Slide the axle through the holes in the bottom
of the cabinet.
2. Slide the wheels on the axle and secure with
the two cotter pins as shown in Figure 7.
Axle
Figure 7. Wheels installed.
3. Screw the threaded portion of the leveling
feet, followed by the flat washer and hex
nut, into the base of the cabinet as shown in
Figure 8.
4.
Adjust the feet to level the bandsaw as need-
ed.
G0561 7" x 12" Metal-Cutting Bandsaw
Hex Nut & Flat Washer
Qty
Figure 8. Leveling feet installed.

Chip Screen

The chip screen is designed to prevent chips and
cut-offs from entering the coolant tank.
Components and Hardware Needed:
Chip Screen ........................................................1
To install the chip screen:
1.
Place the chip screen into the opening shown
in Figure 9.
Chip Screen
Figure 9. Chip screen installed.
Leveling Feet
Qty
-17-