Pulley Cover - Grizzly G0561 Owner's Manual

Pulley Cover

Components and Hardware Needed:
Pulley Cover ......................................................1
Collar ..................................................................1
Phillips Head Screws ⁄
1
4
Flat Washers ⁄ " .................................................2
1
4
Knob ⁄ "-20 x ⁄ " ................................................1
1 5
4 8
To install the pulley cover:
1. Slide the collar onto the bottom side of the
pulley cover and snap in place as shown in
Figure 10.
Figure 10. Collar installed.
Entanglement
You MUST install the pul-
ley cover before operat-
ing or severe injury may
occur.
-18-
Qty
"-20 x ⁄ " .......................2
5
8
Hazard!
Figure 11. Installing pulley cover.
2. Slide the pulley cover over the pulleys.
3.
Align the holes and secure with the two
20 x ⁄ " Phillips head screws and four flat
5
8
washers (see Figure 11).
Knob
Figure 12 Secured pulley cover lid.
4. Close the pulley cover lid and secure with the
knob (see Figure 12).
G0561 7" x 12" Metal-Cutting Bandsaw
⁄ "-
1
4