Standby/Hibernation - Toshiba TECRA S1 Series User Manual

A CONNECT display
is quickly replaced by
NO CARRIER
Character display
becomes garbled
during a
communication
You cannot receive
an incoming call

Standby/Hibernation

Problem
The system will
not enter
Standby/Hibernation
Hardware and system checklist
Check the error control setting in your
communications application.
You can also use the AT\N command. Refer to
the chapter on AT commands in online help files
for Appendix C, AT Commands.
In data transmission, make sure the parity bit
and stop bit settings correspond with those
of the remote computer.
Check the flow control and communication
protocol.
Check the rings before auto answer setting in
your communications application.
You can also use the ATS0 command. Refer to
the chapter on S-registers in online help files for
Appendix D, S-registers.
If problems persist, contact your dealer.
Procedure
Is Windows Media
might not enter Standby/Hibernation, if Windows
Media Player is either playing a selection or
finished playing a selection. Close Windows
Media Player before you select Standby/
Hibernation.
If problems persist, contact your dealer.
™
Player open? The system
9-23