Device Config; Pointing Devices - Toshiba TECRA S1 Series User Manual

User's Manual
You will not be able to access the password option in the HW Setup. In
this case you must turn the power off and back on to retry the procedure.
4. Follow the same procedures described in the earlier section, How to set the
password, to set a new user password.

Device Config

Device Configuration
This option lets you set the device configuration.
All Devices
Setup by OS
Parallel/Printer
This tab lets you set the Printer Port Type. Use the Windows Device Manager to
make settings for the Parallel port.
Parallel Port Mode
The options in this tab are ECP and Standard Bi-directional.
ECP
Standard
Bi-directional

Pointing Devices

Pointing Devices
This tab lets you select Auto-Selected and Simultaneous.
Auto-Selected
Simultaneous
7-4
BIOS sets all devices.
Operating system sets devices that it can control.
Sets the port type to Extended Capabilities Port (ECP). For
most printers, the port should be set to ECP. (Default)
This setting should be used with some other parallel
devices.
If a PS/2 mouse is connected to the computer when you
turn on the power, the PS/2 mouse is enabled and the
AccuPoint is disabled. Otherwise, the AccuPoint is
enabled. (Default)
Enables both the AccuPoint and a PS/2 mouse.