Usb Fdd Kit; Advanced Port Replicator Ii - Toshiba TECRA S1 Series User Manual

USB FDD Kit

The 3 1/2" external FDD drive module can be connected to the USB port. For details
on connecting the 3 1/2" external diskette drive module, refer to Chapter 4,
ing Basics.

Advanced Port Replicator II

In addition to the ports available on the computer, the Port Replicator provides,
audio line-out jack, line-in jack and separate ports for PS/2 mouse and PS/2
keyboard. The Port Replicator connects directly to the docking interface on the
bottom of the computer. The AC adaptor connects the Port Replicator to a power
source.
CAUTION: The computer must be configured properly before connecting
to a LAN. Logging onto a LAN using the computer's default settings
could cause a malfunction in LAN operation. Check with your LAN
administrator regarding set-up procedures.
The following ports and accessories are available on the Port Replicator.
One RJ45 LAN jack
One RJ11 Modem jack
External monitor port
Parallel port
Serial port
PS/2 mouse port
PS/2 keyboard port
DC IN socket
Security lock slot
Audio line-in, line-out jacks
Universal Serial Bus (two) ports
i.LINK (IEEE 1394) port (This port is not supported by the computer.)
DVI port (This port is not supported by the computer.)
NOTES: 1. When a Port Replicator is connected to the computer,
remove all cables connected to the computer.
2. The TECRA S1 does not support the DVI and i.LINK ports
on the Port Replicator.
Advanced Port Replicator II
Operat-
8-11