Blower - FireplaceXtrordinair 35 Custom Builder Owner's Manual

Optional Equipment
4 2
Face Mounting Kit (for mounting 36 DV Faces)
See the instructions on page 14.

Blower

(part # 99000155)
! Do not connect 110-120 VAC to the gas control valve or wiring system of this unit.
1 Attach the rheostat bracket to the fireplace following the directions below.
Attach the molex connector from the
a
blower wiring harness to the molex
connector protruding from the fireplace.
1/4" Nutdriver
Remove this screw and
b
attach the ground wire
from the wiring harness to
the fireplace.
Travis Industries
TO POWER
SOURCE
1/4" Nutdriver
9 3 5 0 8 1 1 6
(for qualified installers only)
(part # 98500536)
c
Secure the rheostat bracket to the fireplace with two
screws (note how the rear of the bracket has a slot that
accepts the screw already installed in the fireplace).
NOTE:
This snap disk must contact the bottom of the firebox -
bend the bracket, if necessary to ensure contact.
0 3 1 0 0 0