Hardware Identification Chart - Stamina Elliptical /Stepper Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers, the
ends of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
80
81
83
91
86
87
90
92
70
72
73
69
68
93
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Carriage Bolt (M8 x 1.25 x 70mm)
Bolt, Socket Head (M6 x 1 x 35mm)
Bolt, Button Head (M8 x 1.25 x 90mm)
Bolt, Button Head (M10 x 1.5 x 85mm)
Bolt, Hex Head (M8 x 1.25 x 50mm)
Bolt, Hex Head (M8 x 1.25 x 20mm)
Bolt, Round Head (M8 x 1.25 x 20mm)
Screw, Round Head (M5 x 0.8 x 30mm)
Nylock Nut (M10 x 1.5)
Nylock Nut (M6 x 1)
Nylock Nut (M8 x 1.25 x 8mm thick)
Lock Washer (M8)
Washer (M10)
Washer (M5)
5
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
4
4
2
2
2
1
4
1
2
4
8
1
2
1