Hardware Identification Chart - Stamina Total Body Pro Elliptical 55-1702 Owner's Manual

This chart is provided to help identify the hardware used in the assembly process. Place the washers or
the ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to
check the length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws, except those with flat
heads, is measured from below the head to the end of the bolt
or screw. Flat head bolts and screws are measured from the
top of the head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.

HARDWARE IDENTIFICATION CHART

5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part Number and Description
38
39
40
58
59
60
62
63
66
67
68
70
71
72
73
74
75
44
48
51
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Tooth Lock Washer (M8)
Flange Nut, Brass Color (M10 x 1.25, Left Hand Threads)
Flange Nut, Black Color (M10x1.25, Right Hand Threads)
Carriage Bolt (M8 x 1.25 x 65mm)
Bolt, Button Head (M8 x 1.25 x 20mm)
Bolt, Button Head (M8 x 1.25 x 48mm)
Bolt, Flat Head (M8 x 1.25 x 65mm)
Bolt, Hex Head (M6 x 1 x 36mm)
Screw, Round Head (M5 x 15mm)
Screw, Flat Head (M5 x 0.8 x 15mm)
Nylock Nut (M8 x 1.25)
Acorn Nut (M6 x 1)
Acorn Nut (M8 x 1.25)
Arc Washer (M6)
Arc Washer (M8)
Lock Washer (M6)
Lock Washer (M8)
Large Washer (M8 x 32mm x 2mm thick)
Plastic Washer (M8 x ø18 x 2mm thick)
Large Washer (M16 x 0.5mm thick)
6
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
2
1
1
2
6
4
2
4
6
1
4
4
2
4
6
4
8
2
8
2