Set Up Instructions - Stamina Elliptical /Stepper Owner's Manual

SET UP INSTRUCTIONS

Elliptical / Stepper
Place the
Stepper
be placed on an equipment mat. The max. operation dimensions of
approximately 53 1/2" long x 28" wide x 61 3/8" tall. (These dimensions may vary up to one inch.) An area
4 feet wide x 6.5 feet long is required for safe operation of the
space is available for access to and passage around the
LEVELING: Adjust the
Elliptical / Stepper
illustration.
MOVING: Grasp the
/ Stepper
Equipment Mat
FUNCTION INSPECTION:
Elliptical / Stepper
Visually inspect the
Elliptical / Stepper
the function of the
position on the handlebars. Slowly move your highest foot forward and follow the natural path of the machine.
Turn the crank slowly through one complete revolution to verify that the drive train functions properly. Adjust
TENSION KNOB(27)
the
CAUTION:
Locate and read the
users read the
in the area where it will be used. It is recommended that the
LEVELING STANDS(60)
sets on the floor without rocking. Refer the instructions below the
REAR STABILIZER(3)
to move. Two people are required.
to verify that assembly is as shown in the above illustration. Check
. Stand on the foot pedals and place your hands at a comfortable
and verify that it functions properly.
WARNING LABEL(97)
WARNING LABEL(97).
Elliptical / Stepper.
Elliptical / Stepper.
FRONT STABILIZER(2)
under the
STATIONARY HANDLEBAR
and
Loosen the NUTS(M8)(96) to touch the
LEVELING STANDS(60). Adjust the LEVELING
STANDS(60) for leveling. Tighten the NUTS(M8)
(96) securely against the FRONT STABILIZER
(2) to lock the stand in position.
Elliptical / Stepper
on the
11
Elliptical / Stepper
Make sure that adequate
to lift the
Stationary Handlebar
. Make sure that all
Elliptical /
are
so that the
Elliptical