START/STOP SCHEDULE: Switches between running a schedule and
manual (permanent override). Cancels a temporary override.
EDIT SCHEDULE: Use this button to start editing the schedule. Push
repeatedly to move through the selections.
SELECT: Used to select the days that the new schedule will be copied to.
SET TIME: Sequences through the hour, minute and day.
LIGHT BAR: Turns on the display back light for 10 seconds.
FAN: Turns fan to AUTOMATIC, CIRCULATE or ON.
UP ARROW: Used during programming to increase the flashing item.
DOWN ARROW: Used during programming to decrease the flashing item.
HEAT/COOL: Toggles through OFF, HEATING, COOLING, and AUTO. If using
an RS6220 and configured as HP then emergency heat is also displayed.
To Make Changes in the Schedule
This thermostat can operate using a single setpoint by overriding the
schedules. If you will be using this thermostat for single setpoint operation
skip to Overriding the Schedule.
Use the following table to document your schedule settings before editing
the schedule on the thermostat.
M M o o r r n n i i n n g g
D D a a y y
E E v v e e n n i i n n g g
N N i i t t e e
Press START/STOP SCHEDULE at any time to exit and save your settings.
Push START/STOP SCHEDULE. The display will show a day flashing at the
top.
T T i i m m e e
C C o o o o l l
6
H H e e a a t t