To Make Changes To The Settings - Robertshaw RS6110 User Manual

If a button is not pushed in 30 seconds the thermostat returns to
operation.
Use the
Push EDIT SCHEDULE to display the first setting. The hour will be flashing.
Use the
Push EDIT SCHEDULE to move to minutes.
Use the
Push EDIT SCHEDULE to move to the heat or cool temperature setting.
Use the
Pressing
to change the setpoint.
- OR -
Push EDIT SCHEDULE to move from heat to cool or cool to heat
temperature setting. Use the
setpoint.
NOTE: THE HEATING AND COOLING SETPOINTS CANNOT
BE ENTERED AS "CROSSED" . THAT IS, THE COOLING
SETPOINT IS LOWER THAN THE HEATING SETPOINT.
Push EDIT SCHEDULE and repeat this process for the remaining three
settings.
After the schedule is complete pressing EDIT SCHEDULE will enter into a
copy program. To skip the copy program and move to the next day, press
EDIT SCHEDULE and repeat the above steps.
To begin selecting days for the copy program, use
highlight each day of the week. If the highlighted day should use the
same schedule, press SELECT to turn on that day. Once all the days that
will use this schedule are selected, press EIT SCHEDULE. The settings
will be copied to the selected days.
If there are more days to program, the next unprogrammed day will be
blinking. Repeat the steps above until all days have been programmed.
When finished press START/STOP SCHEDULE or wait 30 seconds and the
thermostat will return to operation.

To Make Changes to the Settings

When and
display the current settings in order.
To change any setting:
When the setting is visible and flashing press the
arrows to adjust the number on the screen.
or to select the day to be changed.
or to change the hour of the start time if desired.
or to change the minutes of the start time if desired.
or to change the temperature setpoint.
will switch between cooling and heating. Use
are pressed at the same time the thermostat will
or to change the temperature
7
and
and to
or