Table of Contents
Advertisement
1.2 Installation
Location
Place the charger on a flat, even surface. Do not install the charger, phone and accessories in the proximity of:
Water, moisture or damp areas.
·
Sources of heat, direct sunlight or unventilated areas.
·
Devices which generate strong magnetic fields, electrical appliances, fluorescent lamps, computers, radios,
·
televisions or fax and phones.
Areas where the phone can be covered, its ventilation is impaired and liquid can get inside. Areas where there is
·
excessive dust and areas subject to vibration, shock or extreme temperature fluctuations.
Install/keep the phone and accessories out of reach of small children.
·
Commissioning your Telephone
Your phone is only operational after the batteries have been charged. You can then use the phone to make and receive
calls.
Placing the batteries in the phone
The battery compartment is on the back of the hone. It takes the three type AAA batteries which are supplied.
1.
Opening the battery compartment cover:
Insert a suitable item (e.g. the top of a ballpoint pan) into the hole at the bottom of the compartment cover(1). Push
it in and lift the cover at the same time (2).
2.
Inserting the batteries:
Insert the batteries in the battery compartment, taking care to observe the correct polarity. The + - poles of the
batteries must correspond to the + - markings in the battery compartment.
3.
Closing the battery compartment cover:
Replace the cover by placing it on the compartment at a slight angle (1) and pressing it down until it clicks into place
(2).
Note
If the batteries are inserted incorrectly, the telephone will not function, and may be damaged.
·
3711 Phone
IP Office
Avaya 3711 Telephone: Important Safety Information
15-601084 Issue 05b (03 October 2008)
Page 9
Advertisement
Table of Contents
