Table of Contents
Advertisement
F. Junction Box Installation
If the box is being wired from the OUTSIDE of the appli-
ance:
•
Remove the cover plate located on the outer shell - right
side (see Figure .4).
•
Install the supplied Romex™ connector in the cover
plate.
If the box is being wired from the INSIDE of the appli-
ance:
•
Remove the screw attaching the junction box/receptacle
to the outer shell, rotate the junction box inward to
disengage it from the outer shell (see Figure .4).
•
Pull the electrical wires from outside the appliance
through this opening into the valve compartment. See
Figure .4.
G. Wall Switch Installation for Fan (Optional)
If the box is being wired to a wall mounted switch for use
with a fan (See Figure .5):
•
The power supply for the appliance must be brought into
a switch box.
•
The power can then be supplied from the switch box
to the appliance using a minimum of 4- with ground
wire.
•
At the switch box connect the black (hot) wire and red
(switch leg) wire to the wall switch as shown.
•
At the appliance connect the black (hot), white (neutral)
and green (ground) wires to the junction box as
shown.
•
Add a /4 in. insulated female connector to the red
(switch leg) wire, route it through the knockout in the face
of the junction box, and connect to the top fan switch
connector (/4 in. male) as shown.
Figure 13.4 Junction Box Detail
Figure 13.5 Junction Box Wired to Wall Switch or BC10
Heatilator • Eclipse • 4049-229 Rev I • 08/09
GRN wire
inside box
Minimum 14-3 AWG
with Ground
Red
Black
White
Green
Junction Box
Knockout
Red
Romex
Connector
14/2WG
Cover Plate
outside firebox
Copper
ground attached
to GRN screw with
GRN wire
NOTICE: DO NOT wire
110 VAC to wall switch.
Switch
Black
White
Green
Power
Switch Box
Supply
Wires
45
Hide quick links:
Advertisement
Table of Contents
