Table of Contents
Advertisement
•
Place a small amount of /2 in. ( mm) diameter pieces
(dime-size) of rockwool on the burner pan so that the
rockwool touches but does not cover the holes in the
burner pan. This will provide the "glowing embers"
look. It is not necessary to use the entire bag. Save the
remaining rockwool for future use. See Figure 5.6.
Figure 15.6 Placement of Rockwool
E. Replace Glass
Replace the glass assembly on the lower access latches
and rotate the upper portion of the glass assembly into
place. Engage the top access latches. Engage lower ac-
cess latches.
F. Install Floor Cover
Place floor cover (painted side up) as shown in Fig-
ure 5.7.
Figure 15.7 Place Floor Cover
48
G. Grilles and Screen
•
Lay top grille face down so the thin tabs are pointing
up.
•
Spread screen out next to the tab side of the grille.
•
Starting with one corner of the screen, thread the first
loop of the screen over the first tab on top grille and
continue threading the screen over tabs along edge of
top grille. Adjust screen so it lays evenly (not bunched
or too tight between tabs).
Figure 15.8 Lay Out Screen
•
Bend tabs 90 degrees away from the screen with needle
nose pliers to secure the screen to top grille. See
Figure 5.9.
Figure 15.9 Bend Tabs to Hold Screen
•
Place the tabs of the top grill over the shoulder screws
on each end. See Figure 5.0.
Figure 15.10 Attach Top Grill - Left Side Shown
Heatilator • Eclipse • 4049-229 Rev I • 08/09
Tab
Hide quick links:
Advertisement
Table of Contents
