Appendix F: Connecting Motion / Alarm Devices - Lorex LH400 LINK SERIES User Manual

APPENDIX F: CONNECTING MOTION / ALARM
DEVICES
You can enable motion detection and alarm control from the Main Menu. You can also connect
additional motion sensor devices to the system (i.e. motion sensors, door/window sensors). Use
a motion detector or sensor to send a signal to the system to begin camera viewing and recording
on the matching camera channel (when enabled in the Menu).
To connect an external alarm sensor to the system:
1. Connect the Signal Cable to the desired in the alarm block.
Channel number + port
2. Connect the Ground cable to the in the alarm block.
Ground port (G)
3. Open the MAIN MENU and select .
ALARM
4. Select the corresponding alarm channel and select .
INPUT
5. Select (Normally closed) or (normally open) depending on your alarm/sensor setup.
N.C. N.O.
Make sure the channel is set to .
ON
6. Press the button to save your settings.
ENTER
DVR*
ALARM or SENSOR
(Not Included)
*8-channel model shown.
78