Table of Contents
Advertisement
61200.129L1-1
REVIEW TEMP
This menu item is operated the same for the TEMP
map as is 3)REVIEW MAP A or MAP B.
EDIT TEMP
The map in the TEMP file can be edited to whatever
configuration is desired. If Map A had been copied
into the TEMP file, then after editing, the TEMP file
could be applied to MAP A or MAP B.
With the cursor on 5)EDIT TEMP, press Enter to
display the selection screen with the cursor on the first
DS0 number. The menu displays are identical to
2)CREATE TEMP with the exception that the existing
values (for Passthru and Port Select) are displayed.
Complete the editing of the scratch file the same as for
2)CREATE TEMP.
APPLY TEMP > A
Writes the TEMP map into Map A. Apply is usually
the last step in updating a map and is accessed auto-
matically at the end of editing or creating a temporary
map. It can be bypassed at this time by selecting
another menu choice.
Selecting Apply will disrupt normal data flow while the
current map is overwritten with the new map. This will not
cause a switch of the executing map; i.e., if Map A were
modified while Map B was executing, selecting Apply will
rewrite Map A but will not switch execution from Map B to
Map A.
Access 6)APPLY TEMP > A by following standard
operating procedures or by completing a scratch map.
Press Enter or number 6. The unit displays DISRUPT
DATA: YES or NO.
Scroll to select Yes or No.
Yes
The display shows MAP APPLIED.
No
The system returns to menu item 6)APPLY.
TSU 120 User Manual
Chapter 3. Operation
7 1
Advertisement
Table of Contents
