Optional Enhanced Ram+ Second Station Mic Installation - Vertex Standard VM-3500E Owner's Manual

6.10 OPTIONAL ENHANCED RAM+ SECOND STATION MIC INSTALLATION

The VM-3500E is capable of using an Enhanced RAM+ MIC to remotely con-
trol the Radio, DSC and PA/Fog functions. In addition the VM-3500E can oper-
ate as a full function intercom system.
1. Connect the RAM+ MIC Cable to the RAM MIC CONNECTOR on the rear
panel, then tighten the Cable Nut (See Figure 3).
2. Referring to Figure 3, make a 30 mm hole in the wall, then insert the RAM+
MIC Cable into this hole. Connect the Gasket and Mount Base to the RAM+
MIC Cable Connector using the Nut.
3. Drill the four Screw holes (approx. 2 mm) on the wall, then install the Mounting
Base to the wall using four screws.
4. Put the Rubber Cap on to the Nut. The installation is now complete.
5. Wires for a external speaker are provided on the RAM+ mic cable. Connect
any 8 Ohm external speaker. When connected the RAM+ controls the vol-
ume level of this speaker.
RAM+ or External Speaker Selection
By default the RAM+ internal speaker is turned on, however using the RAM+
mic this speaker can be turned off so the external speaker can be used.
1. Press and hold the [ CALL/SET ] key on the RAM+ Mic.
2. Using the [
" and press the [ CALL/SET ] key.
SPK
3. Press the [ ] or [ ] key to turn the RAM+
Speaker " oF ."
4. Press the [ 16/9 ] key to exit this mode.
Figure 3. Enhanced RAM+ MIC Installation
VM-3500E
] or [ ] keys to select "
RAM
EXP SP Cable for the RAM+ MIC
Wall
Gasket
RAM MIC Cable
Mounting Bracket
Cap
Nut
Page 15