Belt Clip Installation And Removal; Mic/Sp Cap Installation - Vertex Standard VX-261 Operating Manual

Belt.Clip.Installation.and.Removal
r To install the Belt Clip: align the
Belt Clip to the groove of the Bat-
tery pack, then press the Belt Clip
downward until it locks in place
with a "Click."
8
b Y b
eFore ou egin
r To remove the Belt Clip: use a
flat head screw driver to press the
Belt Clip Tab away from the bat-
tery pack to unlock the Belt Clip,
then slide the Belt Clip upward to
remove it.
Belt Clip Tab
MIC/SP.CAP.Installation
Install the MIC/SP cap with the sup-
plied screws.
r Use. only. the. supplied. screws.
when.install.the.MIC/SP cap.
r This. radio. does. not. keep. the.
Water. Resistant. Rating. (IP55).
when.the.MIC/SP.cap.is.not.in-
stalled.in.the.MIC/SP.jack.
VX-261 O
perating
M
anual