Canon LBP 5300 User Manual page 421

Cause 2
Remedy
Thin, longitudinal lines appear.
Cause
Remedy
Images of red color system come out faint, or white streaks appear.
Cause 1
Remedy
7
Cause 2
Remedy
A phenomenon of "Out-of-Register Colors" occurs.
Cause
Remedy 1 Correct the phenomenon of "Out-of-Register Colors". (See "To Correct a
Remedy 2 Set [Special Print Mode] to [Special Settings 6] in the printer driver. If this solves
7-40 Print Quality Problems
The printer is being used in a low-humidity environment.
Set [Special Print Mode] to [Special Settings 2] in the printer driver. If this solves
the problem, set [Special Print Mode] to [Off].
In order to specify the setting for [Special Print Mode], display the [Advanced
Settings] dialog box by clicking [Finishing Details] in the [Finishing] sheet, and
then clicking [Advanced Settings] in the [Finishing Details] dialog box.
Images were printed.
Set [Special Print Mode] to [Special Settings 4] in the printer driver. If this solves
the problem, set [Special Print Mode] to [Off].
In order to specify the setting for [Special Print Mode], display the [Advanced
Settings] dialog box by clicking [Finishing Details] in the [Finishing] sheet, and
then clicking [Advanced Settings] in the [Finishing Details] dialog box.
Paper is inappropriate.
Replace the paper with one that can be used with this printer. (See "Paper
Requirements," on p. 3-2)
Continuous printing was performed.
Set [Special Print Mode] to [Special Settings 5] in the printer driver. If this solves
the problem, set [Special Print Mode] to [Off].
In order to specify the setting for [Special Print Mode], display the [Advanced
Settings] dialog box by clicking [Finishing Details] in the [Finishing] sheet, and
then clicking [Advanced Settings] in the [Finishing Details] dialog box.
Heavy paper was printed continuously.
Phenomenon of "Out-of-Register Colors" of the Printer," on p. 6-23)
the problem, set [Special Print Mode] to [Off].
In order to specify the setting for [Special Print Mode], display the [Advanced
Settings] dialog box by clicking [Finishing Details] in the [Finishing] sheet, and
then clicking [Advanced Settings] in the [Finishing Details] dialog box.