Installation - Alpine IVX-C806 Owner's Manual

Installation

Installing the Monitor
Place of installation
Before determining the position of installation,
check that the display will not hamper gear
shifting when it is opened and closed in that
position.
NOTE
Install at an angle of within 30 degrees from the
horizontal.
1
Mounting
Bracket
Sleeve
(Included)
Hex Bolt
(Included)
Rubber Cap
(Included)
Dashboard
Slide mounting sleeve from main unit (see
Removal Procedure below). Slide the mounting
sleeve into the dashboard. Install the supplied
bracket to the monitor.
2
Hex Nut
(M5)
Metal
Mounting
Strap
Ground
Lead
Chassis
Mounting
Bracket
(Included)
Screws
(M5x6)
(Included)
Washers
(Included)
IVX-C806/
IVX-M706/
CVA-1006R
Screw
Bolt Stud
IVX-C806/
IVX-M706/
CVA-1006R
Front
Frame
(Included)
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the IVX-C806/
IVX-M706/CVA-1006R and put the Rubber Cap
on the hex bolt. If your vehicle does not have the
Mounting Support, reinforce the monitor unit with
the metal mounting strap (not supplied). Secure
the ground lead of the unit to a clean metal spot
using a screw (≤) already attached to the
vehicle's chassis.
NOTE
For the screw marked ≤≤, use an appropriate screw
for the chosen mounting location.
Connect each input lead coming from an amplifier
or equalizer to the corresponding output lead
coming from the left rear of the IVX-C806/IVX-
M706/CVA-1006R. Connect all other leads of the
IVX-C806/IVX-M706/CVA-1006R according to
details described in the Connections section.
3
Lock Pin
Slide the IVX-C806/IVX-M706/CVA-1006R into
the dashboard. When the unit is in place, make
sure the locking pins are fully seated in the down
position. This can be done by pressing firmly in
on the unit while pushing the locking pin down
with a small screwdriver. This ensures that the
unit is properly locked and will not accidentally
come out from the dashboard. Install the
supplied Front Frame.
Removal
1. Use a small screwdriver (or similar tool) to push
the locking pins to the "up" position (see Step 3).
As each pin is unlocked, gently pull out on the
unit to make sure it does not re-lock before
unlocking the second pin.
2. Pull the unit out, keeping it unlocked as you do
so.
61
-EN