The Test Button - Axis 5400+ User Manual

Section 13

The Test Button

Printing a Test Page
Note:
Printing the
Parameter List
Performing a Factory
Default
AXIS 5400+ / AXIS 5600+ User's Manual
The test button is located on the front right hand side of the AXIS 5400+/AXIS
5600+ and is used for:
• Printing a test page to check the connection to the printer.
• Printing a parameter list to see the print server's current settings.
• Performing a Factory Default of the print server.
If you want to change any of the parameters, use one of the methods described
in Section 1 Print Server Management, on page 86.
Press the test button once to print a test page. The test page contains basic
information about the AXIS 5400+/AXIS 5600+. It is recommended that you
print a test page every time you connect the print server to a printer.
For AXIS 5600+: if just one of ports is connected to a printer, the test page will be printed on
that port. If each port is connected to a printer, the default setting will send the test page to
the parallel printer. The default behavior can be changed from the print server's internal Web
pages under Admin | General Settings =>Change.
Press the test button twice to print a parameter list showing the current AXIS
5400+/AXIS 5600+ settings. This list provides comprehensive details of all the
parameters and their current status. Refer to Section 16 The Parameter List, on
page 130.
1. Remove the external power supply to switch off the print server.
2. Press and hold down the test button, while you reconnect the external
power supply.
3. Continue to hold down the test button until the network indicator remains
constantly lit. This should take about 20 seconds.
4. Restart the print server by disconnecting and reconnecting the external
power supply
.
For print servers with firmware version 6.43 and higher, a Factory Default will
reset all AXIS 5400+/AXIS 5600+ parameters and settings to their default
values, except:
•Installed certificate
•Private key
The Test Button
123