Appendix A Test Button - Axis 560 User Manual

AXIS 560/660 User's Manual

Appendix A Test Button

The Test Page
Note:
The Parameter List
Note:
The test button is located on the front right hand side of the AXIS
560/660 and is used for:
• Printing a test page, checking the connection to the printer.
• Printing a parameter list, showing the AXIS 560/660 current set-
tings.
• Resetting the AXIS 560/660 parameters to the factory default
settings.
Press the test button once to print a test page. If the test page prints,
the parallel interface is functioning correctly. The printed Test Page
contains basic information about the AXIS 560/660. It is
recommended that you print a test page every time you have
connected the AXIS 560/660 to a printer.
The test page is printed on LPT1 by default. If you want to print
the test page on LPT2 or COM1 instead, you should set the
Internal Printout Destination parameter to LPT2 respectively
COM1.
Press the test button twice to print a parameter list showing the
current AXIS 560/660 settings. This list provides comprehensive
details of all the parameters and their current status. Refer to
B - The Parameter List, on page 153.
If you want to change any of the parameters, use one of the methods
that are described in
Section 9 Management & Configuration, on page 108.
The parameter list is printed on LPT1 by default. If you want to
print the parameter list on LPT2 or COM1 instead, you should
set the Internal Printout Destination parameter to LPT2
respectively COM1.
Appendix A: Test Button
151