Axis 5400+ User Manual page 93

The Serial Printer Port
AXIS 5400+ / AXIS 5600+ User's Manual
HP JetAdmin does not support serial printer ports. If you must change the
default settings of the serial printer port of the print server, it is recommended
that you use the AXIS NetPilot. This will become necessary when you are
installing a printer on your serial port. Follow the steps below to change the
serial port parameters using AXIS NetPilot.
1. Start the AXIS NetPilot.
2. Select your AXIS 5400+/AXIS 5600+ and click Install on the AXIS NetPilot
toolbar. Select with current configuration.
3. Your AXIS 5400+/AXIS 5600+ has been transferred to the 'Network Print
Servers' folder. Select your AXIS 5400+/AXIS 5600+ and click the Property
button on the AXIS NetPilot toolbar.
4. Select the Printer Ports tab.
5. Select COM1 from the Printer Port drop-down list.
6. Select XON/XOFF from the Handshake Protocol drop-down list, set the Baud
Rate to 38400 and select 1 stop bit. Click OK.
The settings in step 6 varies between different printer models. Please refer to
your printer documentation.
If your network supports TCP/IP you can also change the serial port parameters
by using the AXIS 5400+/AXIS 5600+ Web interface.
Management and Configuration
93