Xerox D95 User Manual page 395

Remove any jams
Close the finisher cover(s).
2. Follow the instructions shown on the machine UI to resume printing.
3. If fault persists, power off/on the machine.
4. If fault persists, call for service.
013-100
Cause: Jam/fault with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Open the Top Left and Right Covers of the SquareFold Trimmer Module.
2. Carefully remove all sheets and paper scraps from jam clearance areas.
3. Close the SquareFold Trimmer Module Top Left and Right Covers.
4. Check the Trimmer Waste Container:
If full, empty the container and reinsert it in the SquareFold Trimmer Module.
If the container is partially pulled out, push it completely in.
5. If necessary, follow any remaining instructions on the machine's UI.
6. If fault persists, repeat the previous steps; if fault persists after that, call for service.
013-101
Cause: Jam/fault with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Open the Top Left and Right Covers of the SquareFold Trimmer Module.
2. Carefully remove all sheets and paper scraps from jam clearance areas.
3. Close the SquareFold Trimmer Module Top Left and Right Covers.
4. Check the Trimmer Waste Container:
If full, empty the container and reinsert it in the SquareFold Trimmer Module.
If the container is partially pulled out, push it completely in.
5. If necessary, follow any remaining instructions on the machine's UI.
6. If fault persists, repeat the previous steps; if fault persists after that, call for service.
013-102
Cause: Jam/fault with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Open the Top Left and Right Covers of the SquareFold Trimmer Module.
2. Carefully remove all sheets and paper scraps from jam clearance areas.
3. Close the SquareFold Trimmer Module Top Left and Right Covers.
4. Check the Trimmer Waste Container:
If full, empty the container and reinsert it in the SquareFold Trimmer Module.
Xerox ® D95/D110/D125/D136 Copier/Printer
User Guide
SquareFold Trimmer Module
23-17