Xerox D95 User Manual page 262

Interface Module/Interface Cooling Module
Remedy: Perform the following:
1. Open the Interface Module/Interface Cooling Module front door.
2. Carefully remove all sheets and paper scraps from the jam clearance areas.
3. Close the front door. Verify the paper used is within the approved paper
specifications.
048-103
Cause: Paper jam:
A jam occurred during feeding.
A jam notification is displayed on the UI.
Remedy: Perform the following:
1. Open the Interface Module/Interface Cooling Module front door.
2. Carefully remove all sheets and paper scraps from the jam clearance areas.
3. Close the front door. Verify the paper used is within the approved paper
specifications.
048-300
Cause: The Interface Module/Interface Cooling Module front door is open.
Remedy: Close the Interface Module/Interface Cooling Module front door.
048-310
Cause: Interface Module/Interface Cooling Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-311
Cause: Interface Module/Interface Cooling Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-312
Cause: Interface Module/Interface Cooling Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-313
Cause: Interface Module/Interface Cooling Module decurler sensor or belt problem
Remedy: Power off the machine (print engine), then power on. If problem continues,
contact the Customer Support Center.
048-314
Cause: Interface Module/Interface Cooling Module decurler sensor or belt problem
19-10 User Guide