ZyXEL Communications VMG8324-B10A series User Manual page 40

Chapter 4 Network Map and Status Screens
Table 4 Status Screen (continued)
LABEL
CPU Usage
Memory Usage
NAT Session
Usage
Interface Status
Interface
Status
Rate
Registration Status
Account
Action
40
DESCRIPTION
This field displays what percentage of the Device's processing ability is currently used.
When this percentage is close to 100%, the Device is running at full load, and the
throughput is not going to improve anymore. If you want some applications to have
more throughput, you should turn off other applications (for example, using QoS; see
Chapter 9 on page 139).
This field displays what percentage of the Device's memory is currently used. Usually,
this percentage should not increase much. If memory usage does get close to 100%, the
Device is probably becoming unstable, and you should restart the device. See
39.2 on page 313, or turn off the device (unplug the power) for a few seconds.
This field displays what percentage of the Device supported NAT sessions are currently
being used.
This column displays each interface the Device has.
This field indicates the interface's use status.
For the DSL interface, this field displays Down (line down), Up (line up or connected)
and Drop (dropping a call) if you're using PPPoE encapsulation.
For the Ethernet WAN and LAN interface, this field displays Up when using the interface
and NoLink when not using the interface.
For the WLAN interface, this field displays the enabled (Active) or disabled (InActive)
state of the interface.
For the 3G USB interface, this field displays Up when using the interface and NoDevice
when no device is detected in any USB slot.
For the Ethernet WAN and LAN interface, this displays the port speed and duplex setting.
For the DSL interface, it displays the downstream and upstream transmission rate.
For the WLAN interface, it displays the maximum transmission rate or N/A with WLAN
disabled.
For the 3G USB interface, this field displays Up when a 3G USB device is installed in a
USB slot and NoDevice when no device is detected in any USB slot.
This column displays each SIP account in the Device.
If the SIP account is already registered with the SIP server, the Account Status field
displays Registered.
Click Unregister to delete the SIP account's registration in the SIP server. This does not
cancel your SIP account, but it deletes the mapping between your SIP identity and your
IP address or domain name.
If the SIP account is not registered with the SIP server, the Account Status field
displays Not Registered.
Click Register to have the Device attempt to register the SIP account with the SIP
server.
The button is grayed out if the SIP account is disabled.
VMG8324-B10A / VMG8324-B30A Series User's Guide
Section