Chapter 20 VPN
20.4 The IPSec VPN Monitor Screen
Use this screen to check your VPN tunnel's current status. You can also manually trigger a VPN
tunnel to the remote network. Click Security > IPSec VPN > Monitor to open this screen as
shown next.
Figure 138 Security > IPSec VPN > Monitor
This screen contains the following fields:
Table 105 Security > IPSec VPN > Monitor
LABEL
Refresh Interval
Status
Connection Name
Remote Gateway
Local Addresses
Remote
Addresses
Action
20.5 Technical Reference
This section provides some technical background information about the topics covered in this
section.
20.5.1 IPSec Architecture
The overall IPSec architecture is shown as follows.
228
DESCRIPTION
Select how often you want the Device to update this screen. Select No Refresh to have
the Device stop updating the screen.
This displays a green line between two hosts if the VPN tunnel has been established
successfully. Otherwise, it displays a red line in between.
This displays the name of the VPN policy.
This is the IP address of the remote IPSec router in the IKE SA.
This displays the IP address(es) on the LAN behind your Device.
This displays the IP address(es) on the LAN behind the remote IPSec router.
Click Trigger to establish a VPN connection with the remote network.
VMG8324-B10A / VMG8324-B30A Series User's Guide