Edit 802.1X Settings; The Wan Status Screen - ZyXEL Communications VMG8324-B10A series User Manual

5.5.1 Edit 802.1X Settings

Use this screen to edit 802.1X authentication settings. Click the Edit icon next to the rule you want
to edit. The screen shown next appears.
Figure 30 Network Setting > Broadband > 802.1x: Edit
The following table describes the labels in this screen.
Table 13 Network Setting > Broadband > 802.1x: Edit
LABEL
Active
Interface
EAP Identity
EAP method
Enable
Bidirectional
Authentication
Certificate
Trusted CA
Apply
Cancel

5.6 The WAN Status Screen

Click Network Setting > Broadband > Wan Status to open this screen. Use this screen to query
and view the historical traffic transmission rate for a WAN interface in a bar chart. N/A displays if
the specified WAN interface was disconnected at that time.
VMG8324-B10A / VMG8324-B30A Series User's Guide
DESCRIPTION
This field allows you to activate/deactivate the authentication.
Select this to enable the authentication. Clear this to disable this authentication without
having to delete the entry.
Select an interface to which the authentication applies.
Enter the EAP identity of the authentication.
This is the EAP method used for this authentication.
Select this to allow bidirectional authentication.
Select the certificate you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Local Certificates screen.
Select the Trusted CA you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Trusted CA screen.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Chapter 5 Broadband
63