ZyXEL Communications VMG8324-B10A series User Manual page 203

The following table describes the labels in this screen.
Table 90 Access Control: Add/Edit
LABEL
Filter Name
Order
Select Source
Device
Source IP
Address
Select
Destination
Device
Destination IP
Address
IP Type
Select Protocol
Protocol
Custom Source
Port
Custom
Destination Port
Policy
Direction
Enable Rate
Limit
Scheduler Rules Select a schedule rule for this ACL rule form the drop-down list box. You can configure a
Apply
Cancel
VMG8324-B10A / VMG8324-B30A Series User's Guide
DESCRIPTION
Enter a descriptive name of up to 16 alphanumeric characters, not including spaces,
underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you are editing
the ACL rule.
Select the order of the ACL rule.
Select the source device to which the ACL rule applies. If you select Specific IP Address,
enter the source IP address in the field below.
Enter the source IP address.
Select the destination device to which the ACL rule applies. If you select Specific IP
Address, enter the destiniation IP address in the field below.
Enter the destination IP address.
Select whether your IP type is IPv4 or IPv6.
Select the transport layer protocol that defines your customized port from the drop-down
list box. The specific protocol rule sets you add in the Security > Firewall > Service >
Add screen display in this list.
If you want to configure a customized protocol, select Specific Service.
This field is displayed only when you select Specific Protocol in Select Protocol.
Choose the IP port (TCP/UDP, TCP, UDP, ICMP, or ICMPv6) that defines your customized
port from the drop-down list box.
This field is displayed only when you select Specific Protocol in Select Protocol.
Enter a single port number or the range of port numbers of the source.
This field is displayed only when you select Specific Protocol in Select Protocol.
Enter a single port number or the range of port numbers of the destination.
Use the drop-down list box to select whether to discard (DROP), deny and send an ICMP
destination-unreachable message to the sender of (REJECT) or allow the passage of
(ACCEPT) packets that match this rule.
Use the drop-down list box to select the direction of traffic to which this rule applies.
Select this check box to set a limit on the upstream/downstream transmission rate for the
specified protocol.
Specify how many packets per minute or second the transmission rate is.
new schedule rule by click Add New Rule. This will bring you to the Security > Scheduler
Rules screen.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Chapter 15 Firewall
203