Resetting The Handsets - Radio Shack 43-143 Owner's Manual

Beyond the Basics
5. While the handset is registering, HANDSET REGISTERING
will appear in the handset display. When REGISTRATION
COMPLETE is displayed, the handset has been registered
to the base. If REGISTRATION FAILED appears, remove the
handset from the base and try again.
Resetting the Handsets
If you want to register a handset to a different base or replace a
handset with another one, you must first de-register the handset
to clear the existing registration data.
1. When the handset is in standby, press the MENU soft key.
2. Select the DEREGISTRATION menu. ARE YOU SURE?
appears in the display.
3. Use
DEREGISTRATION COMPLETE appears, and you hear a
confirmation tone.
To clear other handset information, please follow these steps:
1. When the handset is in standby, press and hold
more than five seconds.
2. Select the DEREGISTER HS submenu. WHICH HANDSET?
appears.
3. Move the cursor to select the handset ID to be de-registered
from the list, and then press the OK soft key.
4. Move the cursor to select YES, and then press the OK soft
key. ARE YOU SURE? appears.
5. Move the cursor to select YES, and then press the OK soft
key. You will hear a confirmation tone.
NOTE
UP841BH_43-143_OM3.indd 33
or to select YES, and then press the OK soft key.
If the handset cannot contact the base, it will
display OUT OF RANGE. If this happens, see
"Appendix: Handset-Base Registration" on page
90. For instructions on registering the handset, see
page 32.

and # for
12/19/2006 6:55:17 PM