Selecting A Tone Frequency; Searching For The Frequency Of The Tone Squelch Used By The Remote Station - Yaesu FTM-400DR Operating Manual

Using the Tone Squelch Function

Selecting a Tone Frequency

The Tone frequency can be selected from 50 frequencies between 67.0Hz to 254.1Hz.
1
Select the operating frequency.
2
Press and hold M over 1 second.
The Setup Menu appears.
3
Tap [SIGNALING].
4
Tap [1 TONE SQL FREQ].
The tone frequency appears in orange.
5
Select a frequency with the O.
6
Press O shortly.
The tone frequency is set and it appears in green.
7
Press and hold M over 1 second.
Returns to the previous screen.
Reference
• The tone frequency set using the above-described procedure is also effective when only the tone is
sent out.
• By default, the tone frequency is set to 88.5Hz.
Searching for the Frequency of the Tone Squelch Used by the
Remote Station
The frequency of the tone squelch used by the remote station can be searched for and
displayed.
1
Press F shortly.
The Function Menu appears.
2
Tap [SQL] and select [T-TRX].
Tap until the [SQL] display switches to [T-TRX].
3
Press F shortly.
4
Tap [SQL].
Search for the tone frequency starts.
When a coincident frequency is detected, a beep is
emitted and search stops temporarily. The detected
tone frequency blinks.
Reference
• For the operation to perform when scanning stops, see "Selecting a Reception Method When
Scanning Stops" on page (See page 000).
46
FCC ID: K6620345X40
IC: 511B-20345X40