Manually Switching Frequency Steps; Resetting Applied Settings - Yaesu FTM-400DR Operating Manual

Manually switching frequency steps

In factory settings, this unit is set to [AUTO (Step)] mode and automatically selects the
optimum frequency step according to reception frequency. These frequency steps can
be manually changed.
1
Press and hold M over 1 second.
The Setup Menu appears.
2
Tap [CONFIG].
3
Tap [7 FM AM STEP] and select [AUTO].
[AUTO] appears in orange.
4
Set frequency with O.
The frequency step changes in the following order,
each time O is rotated.
[AUTO] → [5.00KHz] → [6.25KHz] → [10.00KHz] → [12.50KHz] → [15.00KHz]
→ [20.00KHz] → [25.00KHz] → [50.00KHz] → [100.00KHz]
Mode can also be selected by pressing the v.
Reference
5
Tap [7 FM AM STEP].
The selected frequency changes from orange to green and set as current setting.
6
Press and hold M over 1 second.
The frequency step is set and the screen returns to the previous one.

Resetting applied settings

Settings and memory content can be returned to factory settings.
1
Press and hold M over 1 second.
The Setup Menu appears.
2
Tap [RESET/CLONE].
Reset screen appears.
3
Tap items to reset.
Select items to reset.
[1 FACTORY RESET]: Returns all applied setting to
[2 PRESET]: Registers the preset screen.
[3 RECALL PRESET]: Displays the preset screen.
[4 MEM CH RESET]: Erases only the registered memory channels.
[5 MEM CH SORT]: Sorts memory registered to A/B Bands.
[6 ARPS RESET]: Returns setting for ARPS to factory settings.
[7 CLONE]: Copy settings of this unit to another transceiver.
4
Tap [OK?]
Settings and memory are reset and returned to factory settings.
Reference Tap [Cancel] to cancel Resetting.
factory settings.
* Settings applied in the Setup Menu are not erased.
FCC ID: K6620345X40
IC: 511B-20345X40
Other Settings
27