Table of Contents
Advertisement
TCP/IP
The TCP/IPv4 and TCP/IPv6 pages allow you to configure the TCP/IP settings on the device. For
instructions refer to
Network Installation
Raw TCP/IP, LPR, IPP
The Raw TCP/IP, LPR IPP page allows you to configure the Raw TCP/IP (Port 9100), LPR (Line Printer
Remote) and IPP (Internet Printing Protocol) settings on the device. For instructions, refer to
Printing
on page 57.
Telnet
The Telnet page allows you to configure Telnet settings on the device.
1.
In the Network Settings link select the Telnet link.
2.
Select Enable to enable the Telnet Protocol.
3.
Enter the required information to configure the following settings:
•
Port Number
•
Login ID
•
Password
Select Apply to save the settings.
4.
WSD
The WSD page allows you to enable the WSD protocol on the device.
1.
In the Network Settings link select the WSD link.
2.
Select Enable to enable the WSD Protocol.
3.
Select Apply to save the settings.
SLP
The SLP page allows you to configure the SLP protocol (Service Location Protocol) on the device.
1.
In the Network Settings link select the SLP link.
Select Enable to enable the SLP Protocol.
2.
3.
Enter the required information to configure the following settings:
•
Scope 1, 2 and 3
•
Message Type
•
Multicast Radius
•
Registration Lifetime
4.
Select Apply to save the settings.
on page 27.
Xerox WorkCentre 3315DN/3325DN/3325DNI
System Administrator Guide
Properties
Windows
157
Advertisement
Table of Contents
