Pentax KC-01 Operating Manual page 196

194
Minimizing Battery Consumption
You can set the monitor to dim and the camera to turn off automatically if
unused for a certain length of time.
Set in [Power Saving] and [Auto Power Off] of the [R Set-up 2] menu.
The monitor brightness goes dim if the camera is unused for a while in
Power
standby mode. The default setting is O (On).
Saving
Press any button to return it to the normal brightness.
The power turns off automatically. Select from [1min.] (default setting),
[3min.], [5min.], or [Off].
Auto
Perform any of the following operations to reactivate the camera.
Power
- Turn the camera off and on again.
Off
- Press the shutter release button halfway.
- Press the N button, 3 button, or M button.
• The Power Saving function does not work while a movie is being recorded or
while the AC adapter is connected to the camera.
• The Auto Power Off function does not work when a slideshow is played back,
or when the camera is connected to a computer with an USB cable.
Correcting Defective Pixels in the CMOS Sensor (Pixel
Mapping)
7
Pixel Mapping is a function for mapping out and correcting defective pixels
in the CMOS sensor.
Attach a proper lens to the camera before performing pixel mapping.
1
Select [Pixel Mapping] in the [R Set-up 3] menu, and press
the four-way controller (5).
The [Pixel Mapping] screen appears.
2
Press the four-way controller (2) to select [Pixel
Mapping], and press the 4 button.
Defective pixels are mapped and corrected, and the screen that was
displayed before selecting the menu item appears again.
• It takes about 30 seconds to map out and correct the defective pixels.
• When the battery level is low, [Not enough battery power remaining to
activate Pixel Mapping] is displayed on the monitor. Use the AC Adapter kit
K-AC1202 (optional) or install a fully charged battery.