Orientation; Rigging - Chauvet Line Dancer LED User Manual

Mounting

Orientation

The Line Dancer LED™ may be mounted in any safe position, provided there is adequate room for
ventilation.

Rigging

Be sure that the structure can support the weight of the product. Please see the "Technical
Specifications" section of this manual for a detailed weight listing. Mount the product securely. This
may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm in
size. When rigging consider routine maintenance and control panel access. Please see the following
steps for installation.
•
•
•
Do not use a tool on
Line Dancer LED User Manual
If the power link out is intended to be used with multiple product, take into account the
length of each power cable, and mount the products close enough to one another to
accommodate for this.
When aiming the products, you may use the bracket adjustment knob. Loosen the knob,
adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use
tools for this step, as it may cause damage.
Safety cables must always be used.
Hanging
Bracket
the bracket
adjustment knob
7 Rev. 2