Alcatel-Lucent OmniSwitch 6450 User Manual page 97

Managing OmniSwitch 6450 Stacks
To resolve this pass-through condition, simply assign slot 1001 a new saved slot value and reboot the
module. This can be done in either of two ways:
•
Use the stack set slot
to reboot the module:
-> stack set slot 1001 saved-slot 3
-> reload pass-through 1001
•
Use the stack set slot command to assign the new slot value and, using the optional reload syntax in
the command line, reboot the module:
-> stack set slot 1001 saved-slot 3 reload
When the module comes up, it assumes the new, unique slot position—in this case, slot 3—and, because it
now has the highest slot number in the stack, it assumes an idle role (leaving the primary and secondary
roles to slots 1 and 2, respectively). There are now no duplicate numbers in the stack and all elements are
operating normally:
-> show stack topology
NI Role
----+-----------+--------+------+-------+-------+-------+-------+-------+-------
1 PRIMARY
2 SECONDARY
3 IDLE
OmniSwitch 6450 Hardware Users Guide
command to assign the new value, then use the
State Saved Link A
Slot State
RUNNING 1 UP
RUNNING 2 UP
RUNNING 3 UP
July 2012
reload pass-through
Link A Link A
Remote Remote Link B
NI Port State
3 StackA UP
1 StackB UP
1 StackA UP
Roles Within the Stack
command
Link B Link B
Remote Remote
NI Port
2 StackA
3 StackB
2 StackB
page 6-15