Reloading Switches
If there are only two switches in the stack, the switch that was reloaded (the former secondary) resumes
the secondary role when it comes back up.
Primary - Slot 1
Secondary - Slot 2
-> reload secondary
Primary - Slot 1
Booting...
Primary - Slot 1
Secondary - Slot 2
Reloading the Secondary Management Module In a Stack of Two
page 6-30
1
In this stack of two OmniSwitch 6450 switches, the slot
1 switch is the primary management module. The slot 2
switch is the secondary.
The user reloads the stack's secondary management
2
module by issuing the reload secondary command. Any
data flow on the secondary switch's Ethernet is inter-
As the secondary switch reboots, the primary manage-
3
ment module continues to operate without interruption.
Meanwhile the stack has no interim secondary manage-
ment module as the switch reboots.
When the rebooted switch comes back up, it assumes the
4
secondary management role within the stack.
OmniSwitch 6450 Hardware Users Guide
Managing OmniSwitch 6450 Stacks
July 2012