Alcatel-Lucent OmniSwitch 6450 User Manual page 67

OmniSwitch 6450 Switches
For information on booting stand-alone switches and switches in stacked configurations, refer to the
sections below.
Booting an OmniSwitch
The switch does not use an on/off switch. The power cord is the switch's only connect/disconnect device.
The power connector socket is located on the power supply rear panel. For more information, refer to
"OmniSwitch 6450 Chassis and Hardware Components" on page
To boot the switch, plug the power cord into an easily-accessible power source, such as a grounded AC
outlet or an Uninterruptible Power Supply (UPS).
The switch immediately begins the boot process. Allow a few moments for the switch to boot completely,
then verify the status of all LEDs on the switch's front panel. A successful boot displays the following
LED states:
LED States for a Stand-Alone Switch
OK
PRI
STK
PWR
LED States for a Stacked Switch
OK
PRI
STK
PWR
If any of the LED state differs from the states shown in the table above, refer to
information. Contact Alcatel-Lucent Customer Support if the LED state persists.
For information on logging in and configuring your switch, refer to the Getting Started Guide.
OmniSwitch 6450 Hardware Users Guide
Solid green or blinking amber
Solid green
Off or solid amber
Solid Green
Solid green or blinking amber
Solid green (Primary); Amber (Secondary); Off (Idle)
Green
Solid Green
July 2012
4 Booting
2-1.
page 2-5 for more
page 4-1