Reloading Switches; Reloading The Primary Management Module - Alcatel-Lucent OmniSwitch 6450 User Manual

Managing OmniSwitch 6450 Stacks

Reloading Switches

Reloading is essentially a soft boot of a switch. Users can reload stacked modules operating in any role—
i.e., primary, secondary, idle, and pass-through. Refer to the sections below for more information.

Reloading the Primary Management Module

If the switch with the primary management role is reloaded, the switch with the secondary role automati-
cally takes over primary management functions. In other words, the switch with the secondary role
assumes the primary role as soon as the reload is initiated.
Meanwhile, the idle switch with the next lowest slot number automatically assumes the secondary role.
When the reloaded switch (the former primary module) comes back up, it assumes an idle role within the
stack.
To reload the primary management module, use the
be used in the command line, but is not required. For example:
-> reload primary
Note. A primary management module reload can also be scheduled for a later time or date. For informa-
tion on scheduling a primary module reload, as well as additional command details, refer to the
OmniSwitch CLI Reference Guide.
Primary - Slot 1
Secondary - Slot 2
Idle - Slot 3
Idle - Slot 4
-> reload primary
Booting...
Primary - Slot 2
Secondary - Slot 3
Idle - Slot 4
Idle - Slot 1
Primary - Slot 2
Secondary - Slot 3
Idle - Slot 4
Reloading the Primary Management Module In a Stack of Three or More
OmniSwitch 6450 Hardware Users Guide
reload command. The optional syntax primary can
In this stack of four OmniSwitch 6450 switches, the slot
1
1 switch is the primary management module. The slot 2
switch is the secondary. Slots 3 and 4 are operating in
idle roles.
The user reloads the stack's primary management module
2
by issuing the reload primary command. Any data flow on
the primary switch's Ethernet is interrupted.
The secondary switch automatically takes over the pri-
3
mary role. The idle switch with the next-lowest slot num-
ber—in this case,
slot 3—automatically becomes the secondary manage-
When the rebooted switch comes back up, it assumes an
4
idle role within the stack.
July 2012
Reloading Switches
page 6-27