Alcatel-Lucent OmniSwitch 6450 User Manual page 69

Booting OmniSwitch 6450 Switches
5
To change the stop bits value, enter boot serialstopbits, followed by the number of stop bits. Options
include 1 (default) and 2. For example:
Boot > boot serialstopbits 2
6
Verify your current changes by entering show at the boot prompt:
Boot > show
Edit buffer contents:
Serial (console) baud
Serial (console) parity
Serial (console) stopbits
Serial (console) wordsize
(additional table output not shown)
7
You can save your changes to the boot.params file by entering commit file at the boot prompt:
Boot > commit file
When the commit file command is used, changes will not be enabled until after the next switch reboot.
8
You can also save your changes in real time to the switch's running memory by entering commit
system at the boot prompt:
Boot > commit system
Caution. There are two important things to consider when using the commit system command to save
serial connection changes:
•
Output to the terminal may become illegible due to incompatible serial connection settings between the
switch and the terminal emulation software.
•
If you use the commit system command only, changes will not be saved to the switch's boot.params
file and will be lost if the switch is rebooted. To save changes to the boot.params file, refer to step 7.
9
Return to the CLI prompt by entering exit at the boot prompt.
OmniSwitch 6450 Hardware Users Guide
: 19200
: even
: 2
: 7
July 2012
Console Port
page 4-3