Connecting Chassis To Power Source; Ac Power Supply Connections; Powering On A Chassis - Alcatel-Lucent OmniSwitch 6250-24M User Manual

Connecting Chassis to Power Source

Connecting Chassis to Power Source

AC Power Supply Connections

Since the power cord is the switch's only disconnect device, it should be plugged into an easily accessible
outlet. In the event that your power cord is lost or damaged, refer to the specifications below.

Powering On a Chassis

Follow the steps below to power on the chassis using and AC power source:
1
Connect the IEC-60320-C15 end of the supplied power cord to the primary and optional redundant
power supply.
2
Install the cord retainer bracket to the back of each installed power supply bracket using the attach-
ment screws (provided). Place the slotted retainer clip over the bracket with the retainer fingers pointing
down and slide the retainer bracket toward the power supply until it meets the power cord connector.
Insert two screws (provided) into the retainer clip slots and tighten until secure.
Retainer bracket
3
Connect primary and optional redundant power supplies to AC power source.
4
Monitor the chassis as it boots.
page 3-26
Slotted retainer clip
OmniSwitch 6250 Hardware Users Guide
Mounting OS6250 Switches
Secured Power Cord
June 2012