Os6250-Wall-Mnt - Wall-Mounting Installation - Alcatel-Lucent OmniSwitch 6250-24M User Manual

Mounting OS6250 Switches

OS6250-WALL-MNT - Wall-Mounting Installation

1
Follow the proper assembly instructions based on the configuration of the chassis and power supply
trays described in "Assembling OS6250 Switches" on page
2
Orient the wall-mount brackets so that the rubber bumpers are facing down. Attach the brackets to
both the left and right side of the switch, as shown.
3
Attach two additional mounting brackets to the rear portion of the chassis so that the rubber bumpers
are facing down. Attach the brackets to both the left and right side of the switch.
4
Use one person to securely hold the chassis assembly in position on the wall. Mark the location of the
holes in the mounting brackets on the wall.
5
Pre-drill the wall (if required).
Wall surface
Recommended Wall Mount Chassis Orientation (OS6250-WALL-MNT)
page 3-24
Attaching the wall-mount brackets.
OmniSwitch 6250 Hardware Users Guide
Mounting OS6250 Switches
3-6.
Chassis
NOTE: For wall mounting, it is recommended that the
chassis assembly is oriented sideways, with the chassis
front panel facing left, as shown in the diagram below.
June 2012