Memory Scan - Icom IC-92AD Instruction Manual

■ Memory scan

IMPORTANT!: To perform memory scan, 2 or more mem-
ory channels MUST be programmed, otherwise the scan
will not start.
q Push [MR] to select memory mode.
w Set the squelch level.
e While pushing and holding [SCAN](2), rotate [DIAL] to
select the desired scanning type.
• "ALL" for full memory scan; "BAND" for band memory scan,
"MODE" for mode scan, "DUP" (appears only when duplex op-
eration is set) for duplex scan.
• All memory scan selection
FM FM
14 146 010
A
[DIAL]
SCAN:ALL SCAN:ALL
FM
148 800 14
A
• Band memory scan selection
SCAN:BAND SCAN:BAND FM
A
VFO 14 148 800
A
MHz
2
• Mode scan selection
SCAN
B
MR
S.MW
SCAN:MODE SCAN:MODE FM
148 800 14
A
• Duplex scan selection
SCAN:DUP SCAN:DUP
010
PSKIP PSKI
µ 088 088
800
PSKIP PSKI
µ 088 088
800
PSKIP PSKI
µ 088 088
800
PSKI PSKIP
µ 088 088
r Release [SCAN](2) to start the selected scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
t To stop the scan, push [VFO].
• During memory scan
FM
148 800
A
Band memory scan function: Repeatedly scans all
memory channels programmed with any frequencies of
the band programmed in the memory channel selected
for scanning.
Mode scan function: Repeatedly scans all memory
channels in which the same operating mode as the se-
lected memory channel has been programmed.
Duplex scan function: Repeatedly scans two frequen-
cies (transmission/reception) during duplex scan opera-
tion.
10
SCAN OPERATION
µ 012
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
85