Setting The Time The Backlight Stays Lit; Adjusting The Backlight's Brightness; Resetting The Main Remote Control Unit - Denon AVR-3808 Owner's Manual

Setting the Time the Backlight Stays Lit
1
[RC SETUP]
Press and hold in for at least 3 seconds.
The signal transmission indicator flashes twice.
2
[9] [7] [3]
Press , and , in that order.
The signal transmission indicator flashes twice and the backlight
on time setting mode is set.
3
Set the light on time.
The signal transmission indicator flashes twice.
[Settable times] : [1] : 5 sec.
[2] : 10 sec. (Default)
[3] : 15 sec.
[4] : 20 sec.
[5] : 25 sec.
Adjusting the Backlight's Brightness
The display's brightness can be adjusted in 5 steps.
(Default: Step 3)
1
[RC SETUP]
Press and hold in for at least 3 seconds.
The signal transmission indicator flashes twice.
2
[CHANNEL +] [CHANNEL –]
Press or
The display gets one step brighter when [+] is pressed.
The display gets one step darker when [–] is pressed.
3
[RC SETUP]
Press to complete the setting.
Resetting the Main Remote Control Unit
Learning Function
GResetting button by buttonH
1
[MODE SELECTOR]
Press
reset.
2
Press and hold in
The signal transmission indicator flashes twice.
3
[9] [7]
Press , and
The signal transmission indicator flashes twice.
4
Press the button you want to reset twice.
The signal transmission indicator flashes twice.
GResetting by device modeH
1
[MODE SELECTOR]
Press
reset.
2
Press and hold in
The signal transmission indicator flashes twice.
.
3
[9] [7]
Press , and
The signal transmission indicator flashes twice.
4
[MODE SELECTOR]
Press
reset twice.
The signal transmission indicator flashes twice.
for the device you want to
[RC SETUP]
for at least 3 seconds.
[6]
, in that order.
for the device you want to
[RC SETUP]
for at least 3 seconds.
[6]
, in that order.
for the device you want to
System Call Function
1
[RC SETUP]
Press and hold in for at least 3 seconds.
The signal transmission indicator flashes twice.
2
[9] [7] [8]
Press , and , in that order.
The signal transmission indicator flashes twice.
3
[SYSTEM CALL] 1 2 3
Press ( , or ) you want to reset.
4
[RC SETUP]
Press and hold in for at least 3 seconds.
The signal transmission indicator flashes twice.
Punch Through Function
1
[MODE SELECTOR]
Press for the device you want to
reset (TV or SAT/CBL).
2
[RC SETUP]
Press and hold in for at least 3 seconds.
The signal transmission indicator flashes twice.
3
[9] [8] [4]
Press , and , in that order.
The signal transmission indicator flashes twice.
4
[RC SETUP]
Press and hold in for at least 3 seconds.
The signal transmission indicator flashes twice.
All Settings
1
[RC SETUP]
Press and hold in for at least 3 seconds.
The signal transmission indicator flashes twice.
2
[9] [8] [1]
Press , and , in that order.
The signal transmission indicator flashes 4 times.
All the settings are restored to their defaults.
ENGLISH