Rt (Radio Text); Ipod ® Playback; Basic Operation - Denon AVR-3808 Owner's Manual

RT (Radio Text)
"RT" appears on the display when radio text data is
received.
1
<SOURCE SELECT>
Either turn
(AMP mode) to select "TUNER".
2
To operate using the main remote control unit, set the
remote control unit to the TUNER (
(vpage 60 "Remote Control Unit Operations")
3
[SEARCH]
Press to select "RT".
b While receiving an RDS broadcast station, the text data broadcast
from the station is displayed.
b To turn the display off, press op.
b If no text data is being broadcast, "NO TEXT DATA" is displayed.
iPod ® Playback
The music on an iPod can be played by using the Control
Dock for iPod (ASD-1R, sold separately).
The operation can also be performed using the buttons on
[TUNER]
or press the main unit or remote control unit while watching the GUI
menus.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
) mode.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
Basic Operation
1
Make the necessary preparations.
q S et the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod's operating instructions.)
w Assign the Control Dock for iPod's input. w Assign the Control Dock for iPod's input.
: "Source Select" – "
"iPod dock"
2
Either turn
mode) to select the input source assigned in step 1-w
above.
b If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.
: "Source Select" – "
(vpage 37)
3
To operate using the main remote control unit, set the
remote control unit to the iPod mode.
(vpage 60 "Remote Control Unit Operations")
" – "Assign"–
(input source)
(vpage 39)
<SOURCE SELECT> [iPod]
or press (AMP
OK to disconnect.
(iPod screen)
" – "Play"
(input source)
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" .
• Press <ON/STANDBY> or [POWER OFF] and set the AVR-3808's power
to the standby mode before disconnecting the iPod. Also switch
the input source to one to which the GUI menu "iPod dock" is not
assigned before disconnecting the iPod.
NOTE
• Depending on the type of iPod and the software version, some
functions may not operate.
• DENON will accept no responsibility whatsoever for any loss of iPod
data.
ENGLISH