Cdp; Sip Configuration - Fortinet FON-350i User Manual

CDP

The FON-350i can be assigned to employ the Cisco® Discovery Protocol to determine if VLANs
are to be used and the associated VLAN ID. The CDP selection displays only if function_cdp is
enabled in the configuration file. As a default, the CDP parameter is disabled since FortiVoice
does not use VLAN tagging.
To set the CDP status:
• Press the
• Select the desired softkey (Yes or No) to enable or disable CDP.
Changing the CDP status requires a reboot of the phone. When you leave the menu, you will
receive a reboot notice.
When CDP is enabled, VLAN settings are overwritten.

SIP Configuration

The SIP Configuration section contains parameters related to SIP accounts, line appearance,
and other parameters that allow the phone to register and, if required, subscribe for the line
appearance with the appropriate SIP server or PBX.
Lines are assigned to the phone's flexible buttons in consecutive order from the first button. For
each line, the following parameters are available:
• Call Server IP address
• Authorization ID and password
• Line type
• Special line attributes
As a default, the maximum number of lines is two. When the IP phone requires more than two
(2) lines, use the Web Manager or configuration file to change the number of lines and line
parameters.
At a minimum, assign the first line button as an appearance of the user's line. For features
where the IP phone uses one-button line access such as Speed Dial, the IP phone uses the first
line button for the call.
Fortinet Technologies Inc.
button, then select 1. Network Configuration, then 9. CDP.
Page 14 FON-350i Telephone User Guide