Time Signature - DigiTech JamMan SOLO XT Owner's Manual

Time Signature

The JamMan Solo XT allows you to set a time signature before recording a loop. The
default time signature for empty loops is 4 beats per measure. Each time signature
setting represents how many beats are in the measure (i.e. a setting of 2 would
contain 2 beats per measure, a setting of 6 would contain 6 beats per measure, etc.).
Time signature can be adjusted from 2 to 15 beats per measure.
To set the Time Signature before recording a loop:
Select an empty memory location
1.
using the
<UP/DOWN>
( and
LOOP
Press the
2. <SETUP>
times, or until
display.
Press the
3. <UP>
buttons to change the time signature.
Whenever a tempo has been set, the TEMPO button LED will flash red on the first
NOTE:
downbeat of the measure and then green on the remaining beats of the measure. Time signature can
only be changed on empty loops. When accessing the time signature of a previously recorded loop,
the time signature will appear in the display, but it cannot be changed.
44
buttons
LEDs will be off).
SINGLE
button three
appears in the
SIg
and
<DOWN>
Once the desired selection has been
4.
made, press the
twice to store the changes before
recording your loop or press the
<PEDAL SWITCH>
menu without storing.
button
<STORE>
to exit the Setup