Playing Back Loops Using Jamsync - DigiTech JamMan SOLO XT Owner's Manual

Playing Back Loops Using JamSync

To initiate playback on synced JamSync devices:
Press the
1. <PEDAL SWITCH>
slave device which you want to arm
for playback. The
flash green, indicating the slave device
is armed for sync playback.
Press the
2. <PEDAL SWITCH>
master device to initiate playback. The
master device will begin playing back
along with any slaved devices which
were armed for playback in step 1.
To then cue slaved devices for
3.
playback, press the slave device's
<PEDAL SWITCH>
during master loop playback. The
LED will flash green,
STATUS
indicating the slave device is cued for
sync playback. The slave device will
begin playing back the next time the
master device's loop start point is
reached.
on any
LED will
STATUS
on the
at any time
To stop loop playback of a slave
4.
device, quickly press the
SWITCH>
To stop loop playback of all devices,
5.
quickly press the master's
SWITCH>
<PEDAL
twice.
<PEDAL
twice.
39